CCD Linear Sensors by TOSHIBA

CMOS-Logo

Similar to SONY and NEC, TOSHIBA offers a range of CCD linear sensors for applications, which require a low or medium signal quality. Beside monochrome linear sensors, there are also high resolution colour sensors available, which consists of three or even more parallel pixel lines and respective RGB filters.

EURECA Messtechnik buys these components at the official german distributors. Due to the high bought volumes, we can offer these sensors for very good prices also in lower quantities.


If the sensors provide a glass cover we offer also the service of removing this cover. This is e.g. necessary, if special filters or a fiber optic should be put directly onto the sensor.

You can find a list of sensors, which are not produced any more on our page with obsolete sensors

Hamster Paul mitZeilensensoren



 


Monochromatic Linear Sensors with rectangular pixels

The following types are CCD sensors for very light sensitive applications (e.g. spectroscopy or barcode readers).

Type Pixel Pixel Size 
[µm]
Data
Rate 
[MHz]
Sensitivity
[V/lx ×s]
Dynamic Line
Length 
[mm]
Features
Small
volumes
from stock 
TCD1201DG 2048 14 × 200 2 80 400 28,7
High Sensitivity
 
TCD1205DG 2048 14 × 200 2 80 400 28,7
High Sensitivity, USB camera board available
TCD1304DG 3648 8 × 200 1 160 300 29,2
High Sensitivity, USB camera board available

For some of the listed sensors on this page we can supply also an USB camera board.

All these sensors can be delivered also without the standard glass cover. By this reflexions caused by the glass cover can be avoided. Also the spectral sensitivity of the sensor can so be slightly improved. Sensors without glass cover have the additional designation "-X" (TCD1201DG-X, TCD1205DG-X and TCD1304DG-X).


Monochromatic Linear Sensors with square pixels

The types below are CCD sensors with square pixels. These are suitable for scanning objects or documents.

Type Pixel Pixel Size 
[µm]
Data
Rate 
[MHz]
Sensitivity
[V/lx ×s]
Dynamic Line
Length 
[mm]
Minimum
Order
Volume
Features
Small
volumes
from stock 
TCD132DG 1024 14,0 × 14,0 2 12 2000 14,3 1
Low pixel number
 
TCD1209DG 2048 14,0 × 14,0 20 31 2000 28,7 1
High Speed
TCD1703C 7500 7,0 × 7,0 2 × 20 15 1667 35,0 150
Standard
2 read out registers
TCD1704DG 7500 7,0 × 7,0 4 x 20 17 2500 52,0 50
High Sensitivity
4 read out registers
Will become obsolete.
Do not use for new developments!
 
TCD1706DG 7400 4,7 × 4,7 4 x 25 15   34,8 10 4 read out registers
TCD1708D 7450 4,7 × 4,7 2 x 15 15 2600 35,0 100
High Sensitivity
2 read out registers
TCD1709D 7500 7,0 × 7,0 4 x 25 15 2500 52,5 1 Große Zeilenbreite
4 read out registers




Colour Sensors

CCD color sensors are suitable for the scanning of coloured objects or documents. As accessory, we offer also filters, which enhance the reproduction of colors, in case of difficult situations. At applications outside, there are often, for example, colors distortions by the high IR-proportion of the sunlight. By using of corresponding filters, this can be avoided.

Type Pixels per
Colour 
Pixel Size 
[µm]
Data
Rate 
[MHz]
Sensitivity
[V/lx ×s]
Dynamic Line
Length 
[mm]
Minimum
Order
Volume
Features
Small
volumes
from stock 
TCD2558DG-1 3 x 5340 7,0 × 7,0 3 x 10  R 8,5 
G 12,7 
B 9,5
  37,4 100
High Sensitivity
3 parallel sensor lines
TCD2561DG-1 4 x 5340 7,0 × 7,0 4 x 10 R 10,4
G 14,4
B 8,7 
B/W 21,0 
B/W: 5000
RGB: 8750
37,4 100
High Sensitivity
4 parallel sensor lines

There are new leadless (PB-free) versions of the TOSHIBA sensors available, which fullfill the RHoS standard. These new types are designated with an additional "G", as e.g. TCD1205DG. The optical and electrical specifications of the older and the newer sensor versions are however the same.

The data rate indicates, with which rate the analog sensor signal can be read out.

The sensitivity of a CCD sensor indicates which output in volts is produced by a pixel after an exposure duration of one second with a density of light of one lux. This value depends apart from the pixel area also on the internal amplification of the output drivers.

The dynamic value gives referring to the resolution, which one can expect after a conversion of the output signal with an analog/digital converter.

The line length in the following table indicates the length of the photo-sensitive CCD lines of the sensor (number of pixels × pixel length) and not the mechanical length of the sensor housing.


Some of the products described on this page are normally always available from stock also in smaller volumes. You can find the respective prices in our latest overview about CCD/CMOS image sensors.


Last updated: 11/30/2009